A residential tanning bed is frequently purchased by people who want to have a tan without bothering to dress up and go to a tanning salon. A tanning bed at property tends to make it much more convenient for a person to get that fantastic tan. But a residential tanning bed also means extra responsibility for the owner. Technology is by no means best, like the humans who use them. Therefore, the house tanning bed could be topic to numerous issues. Fortunately, the owner of such tanning bed need not contact a technician each and every time anything goes wrong with it. Right here is a guide that will be useful for the owner of a residential tanning bed.
If the bed refuses to start off or to turn on, there could be 4 attainable factors:
1. There is no power supplied to the bed
two. There is a undesirable relay
3. There is a loose at the relay
four. There is a loose wire at the dial timer
The owner should inspect the plug and the breaker to make positive that there is energy going to the bed. If the relay is undesirable, then there is no other way to fix the bed but to replace the relay. As for loose wires, all the owner has to do is to tighten the loose connection.
If the lamps dont light up, there are five attainable causes:
1. Malfunctioning lamps
two. Malfunctioning ballast
three. Malfunctioning lamp holder
4. Malfunctioning starter
five. A loose wire at the ballast, or at the lamp holder or at the terminal
For any malfunctioning element of the tanning bed, the owner will need to have to replace it. Discover further about sun tanning by going to our impressive site. The owner need to not attempt to repair it by himself. For the loose wire, the owner may possibly just tighten the loose connection.
If the bench lamps will not light up, the result in could be any of these:
1. The bench is not plugged into the canopy
2. A loose wire in the connector among the bench and the canopy
3. The wire in the bench-to-canopy connector could be burnt
The owner need to verify if the bench is securely plugged into the canopy. If not, he ought to appropriate the situation. The loose wire required only a tightening. But if the wire is burnt, the owner must retrieve some electrical tools so that he can strip the wire and replace the connector.
If the lamps do not work well but the fans are functioning fine, there are only two issues to check:
1. The relay
2. The wire either at the terminal block or the relay
The owner must check no matter whether the relay is malfunctioning or not. If it is not working effectively, this relay ought to be replaced. Any loose wire at the terminal block or at the relay can be corrected by tightening the connection.
For other tanning bed troubles, it is greatest that the owner consults the technician of the tanning bed supplier.. Visit tan lotion to discover where to do this hypothesis.